Precautions for operation of photoelectric weft straightening machine

What are the precautions for the operation of the photoelectric weft straightening machine? The photoelectric weft straightening machine has a computer display, which can display the skew and bending conditions of the weft yarn in real time. The photoelectric weft straightening machine is equipped with a fully digital intelligent probe, each probe has a computer, and all collected materials are transmitted to the intermediate computer through the network, which can effectively improve the control power and prevent the material from decaying. In addition, this weft straightening machine can also add other auxiliary equipment, such as long-distance monitoring, expanding, printing reports and other functions. Precautions for the operation of the photoelectric weft straightening machine 1. During normal operation, it is necessary to ensure that all the probes have fabrics passing through. If the fabric can only cover two probes, the probe selection switch on the panel should be turned to the 2 probe position. If the fabric can cover four probes, the probe selection switch on the panel should be turned to the 4 probe position. Pay attention that the fabric cannot be deviated, otherwise one or more probes will fail to detect the signal and cause malfunction. 2. If the surface of the fabric contains steam due to process requirements, special attention should be paid to the change of the probe signal size, because the steam will blur the surface of the bearing probe and affect the signal formation. The prevention method is to see that the signal becomes small, and wipe the lens bearing the probe with a clean dry cloth. 3. When the equipment is powered on, do not plug and unplug any electrical components in the electric control box. 4. After the device is powered on, the power supply can be turned off after a delay of at least two minutes. After the device is powered off, it can be powered on again after a delay of at least one minute. It is strictly forbidden to turn on and off the power frequently. (Otherwise, the service life of the equipment will be greatly shortened) 5. The door of the electric control box should be closed to avoid the entry of dust and corrosive gases, which will affect the electrical reliability. 6. When the signal is small, wipe the dust-proof glass on the cloth end of the transmitting/receiving probe with a dry soft cloth (without wool) to keep the glass surface clean and tidy. 7. Usually, the placement angle and front and rear orientation of the receiving probe cannot be adjusted at will.

https://www.hans-machinery.com/